BGGQT - ASEPTICARE (AEROSOL)
- MSDS: BGGQT
- Manufacturer: AIRKEM PROFESSIONAL PRODUCTS DIV OF ECOLAB INC
- Product Name: ASEPTICARE (AEROSOL)
- National Stock Number: 6840-01-035-6465
Product Identification
Product ID:ASEPTICARE (AEROSOL)
MSDS Date:09/18/1989
FSC:6840
NIIN:01-035-6465
MSDS Number: BGGQT
Responsible Party
ST. PAUL, MN 55102-1307
US
Emergency Phone: 800-328-0026
Info Phone: 612-451-4115
Cage: 89044
Contractor
Telephone: 800-328-0026
Cage: 89044
Ingredients
ETHYL ALCOHOL (ETHANOL)
CAS: 64-17-5
RTECS: RQ6300000
Fraction By Weight: 65%
OSHA PEL 1000 PPM
ACGIH TLV: 1000 PPM; 8990
PROPANE
CAS: 74-98-6
RTECS: TX2275000
Fraction By Weight: 20% MIX
OSHA PEL 1000 PPM
ACGIH TLV: ASPHYXIANT; 9192
ISOBUTANE MIXED WITH PROPANE, 74-98-6/75-28-5
CAS: 75-28-5
RTECS: TZ4300000
Fraction By Weight: 20% MIX
Hazards
LD50 LC50 Mixture:NONE SPECIFIED BY MANUFACTURER.
Routes of Entry: Inhalation:YES Skin:YES Ingestion:NO
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:MAY CAUSE IRRITATION TO THE EYES AND
SKIN. MAY BE HARMFUL IF INHALED. MAY CAUSE BREATHING DIFFICULTIES,
DIZZINESS, HEADACHE OR UNCONSCIOUSNESS.
Explanation of Carcinogenicity:NONE OF THE COMPOUNDS IN THIS PRODUCT IS
LISTED BY IARC, NTP, OR OSHA AS A CARCINOGEN.
Effects of Overexposure:SEE HEALTH HAZARDS.
Medical Cond Aggravated by Exposure:PERSONS WITH A HISTORY OF AILMENTS
OR WITH A PRE-EXISTING DISEASE INVOLVING THE EYES, SKIN, OR
RESPIRATORY TRACT MAY BE AT INCREASED RISK FROM EXPOSURE.
First Aid
First Aid:INHALATION:REMOVE TO FRESH AIR. GIVE O2 IF BREATHING
DIFFICULT. GET MEDICAL ATTENTION. EYES:IMMEDIATELY FLUSH WITH
PLENTY OF WATER FOR 15 MINUTES HOLDING EYELIDS OPEN. GET MEDICAL
ATTENTION. SKIN:REMO VE CONTAMINATED CLOTHING. WASH WITH SOAP AND
WATER. IF IRRITATION PERSISTS, GET MEDICAL ADVICE.
Fire Fighting
Flash Point Method:TCC
Flash Point:<50 F(CONCENTR)
Lower Limits:1
Upper Limits:7
Extinguishing Media:USE CARBON DIOXIDE, FOAM, OR DRY CHEMICAL. WATER
MAY BE INEFFECTIVE, MAY BE USED TO KEEP FIRE EXPOSED CONTAINERS
COOL.
Fire Fighting Procedures:FIRE FIGHTERS SHOULD USE NIOSH APPROVED SCBA &
FULL PROTECTIVE EQUIPMENT WHEN FIGHTING CHEMICAL FIRE. USE WATER TO
COOL NEARBY FIRE EXPOSED CONTAINERS.
Unusual Fire/Explosion Hazard:CONTENTS UNDER PRESSURE. FLAMMABLE.
Accidental Release
Spill Release Procedures:REMOVE ALL SOURCES OF IGNITION. VENTILATE.
AVOID BREATHING VAPORS AND REMOVE WITH INERT ABSORBENT.
Neutralizing Agent:NOT APPLICABLE.
Handling
Handling and Storage Precautions:STORE IN A COOL, DRY, WELL VENTILATED
AREA. KEEP CONTAINERS TIGHTLY CLOSED WHEN NOT IN USE. PROTECT
CONTAINERS FROM PHYSICAL DAMAGE.
Other Precautions:AVOID PROLONGED OR REPEATED BREATHING OF VAPOR. AVOID
CONTACT WITH EYES. USE WITH ADEQUATE VENTILATION. WASH THOROUGHLY
AFTER HANDLING.
Exposure Controls
Respiratory Protection:IF VENTILATION DOES NOT MAINTAIN INHALATION
EXPOSURES BELOW PEL(TLV), USE NIOSH/MSHA APPROVED ORGANIC VAPOR
CARTRIDGE AND DUST/MIST PRE-FILTER RESPIRATORS AS PER CURRENT 29
CFR 1910.134, INSTRUCTIONS/ WARNINGS AND NIOSH-RESPIRATOR
SELECTION.
Ventilation:MECHANICAL (GENERAL) ROOM VENTILATION IS NORMALLY ADEQUATE.
LOCAL EXHAUST MAY BE REQUIRED IF WORK AREA NOT VENTED.
Protective Gloves:NONE NORMALLY REQUIRED.
Eye Protection:SAFETY GOGGLES WITH OPTIONAL FACE SHIELD
Other Protective Equipment:INDUSTRIAL-TYPE WORK CLOTHING AND APRON AS
REQUIRED.
Work Hygienic Practices:OBSERVE GOOD PERSONAL HYGIENE PRACTICES AND
RECOMMENDED PROCEDURES. DO NOT WEAR CONTAMINATED CLOTHING OR
FOOTWEAR.
Supplemental Safety and Health
HMIS DATED 03OCT84 STATES AN EPA REG #42964- 17. THE CURRENT MSDS
PROVIDED BY THE MANUFACTURER DOES NOT GIVE SUCH A NUMBER. THE
ASSUMPTION IS BEING MADE THAT SAID REGISTRATION NUMBER IS THE SAME.
Chemical Properties
HCC:V3
Appearance and Odor:AEROSOL WITH HONEYSUCKLE ODOR
Stability
Stability Indicator/Materials to Avoid:YES
NONE SPECIFIED BY MANUFACTURER.
Stability Condition to Avoid:DO NOT SPRAY NEAR FIRE OR OPEN FLAME. DO
NOT STORE ABOVE 120 F. EXPOSURE TO SUNLIGHT OR OTHER HEAT MAY CAUSE
BURSTING.
Hazardous Decomposition Products:NONE SPECIFIED BY MANUFACTURER.
Disposal
Waste Disposal Methods:DISPOSAL SHOULD BE MADE IN ACCORDANCE WITH ALL
APPLICABLE FEDERAL, STATE AND LOCAL LAWS AND REGULATIONS. DO NOT
PUNCTURE OR INCINERATE CONTAINER.
Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.